The production of the three-piece bag will be more complicated than the one-piece and two-piece bag. There are more points that need to be paid attention to in terms of cutting, stitching and gold sealing. The added outer patch bag will make the bag body thicker. With a 16.5mm diameter, the three-piece capacity is quite sufficient.
Tools and materials required for handmade DIY three-piece gold bag making tutorial:
Inner and outer fabrics, cotton paving, gold stamping, needlework, beading needles, gold medal holder, scissors, water-erasable pen
Handmade DIY three-piece gold bag making tutorial Illustration of the production steps:
Handmade DIY three-piece gold bag production tutorial production step 1:
Let’s deal with the embroidery first , I made a bouquet of roses. I divided the branches of the bouquet into There are two parts, the part with flowers and the part without flowers underneath. The flowery part is made with a longer plain stitch and a short plain stitch at the bottom. Then the symmetry method is good.
Handmade DIY three-piece gold bag making tutorial step 2:
Lock point stitching, there are many other names , I am used to calling it this way. Lock a fewThe point looks more natural and curved.
Handmade DIY three-piece gold bag making tutorial step 3:
In addition, some branches were made Dry extension can be done with backstitching, split stitching or outline embroidery.
Handmade DIY three-piece gold bag making tutorial step 4:
The rose stitch uses curling stitches For needle embroidery, you can use knotted embroidery for small particles.
Handmade DIY three-piece gold bag making tutorial step 5:
The structure of the flower is tightly clustered The center point, so remember not to offset the position of the flower if you made it symmetrical before.
Handmade DIY three-piece gold bag making tutorial step 6:
Small particles are scattered around the branches. lets go!
Handmade DIY three-piece gold bag making tutorial step 7:
The surface and lining fabrics are all cut, and 280g cotton is used to fit the surface fabric, and the lining is also hard lined
Step 8 of the manual DIY three-piece gold bag making tutorial:
Look at this outer bag. The lining is made of lining fabric. In fact, the surface fabric can also be used directly. But I felt the material was too thick so I didn’t have it. And the fabric is actually quite thick. When sewing, sit the outer fabric inside, so that the inside will look more coordinated.
Handmade DIY three-piece gold bag making tutorial step 9:
You can install the suction buckle according to your own requirements Install various suction buttons or buttons according to your preference. Place the raised side here in the pocket, align it with the cotton fabric as a benchmark, find the center point and fix it. The recessed piece is installed on the main body of the bag.
