Homemade sexy bunny girl outfit, it’s very cute, wouldn’t it be fun to DIY a set and seduce him one night!
Main materials:
1 old T-shirt, 1 blank headband, 1 white shirt, 1 black ribbon
1 black bow, 1 piece of white coral velvet, 2 black buttons
Tools required:
Scissors, hand sewing needle and thread, hot melt glue stick, marking powder, positioning pin, hard cardboard
Production steps:
Step 1:
The materials required for the tutorial are as shown below
Step 2:
The tools required for the tutorial are as shown in the figure
Step 3:
As shown in the picture, turn the black T-shirt inside out and draw the shape of a breast-hugging swimsuit on the T-shirt.
Step 4:
Use scissors to cut out the drawn shape, paying attention to leaving more than 1cm margin near the scratch as shown
Step 5:
Sew the cut T-shirt with a needle and thread. Pay attention to the lower part and sew it carefully. You can use a positioning pin to help fix it. If this position is not sewn well, it will affect the wear. XD
Step 6:
Cut out a round piece of coral velvet. Use a needle and thread to sew along the edge of the circle with a flat stitch, then tighten the thread. After closing, you will get a ball-shaped rabbit tail. Pay attention to the thread~
Step 7:
As shown in the picture, sew the finished tail to the appropriate position (butt XD).
Step 8:
As shown in the picture, draw the shape of the rabbits long ears on the cardboard, and cut a pair of symmetrical ones.
Step 9:
Follow the shape of the white cardboard, as shown in the picture, and cut out two layers of cloth of the same shape on the black T-shirt.
Step 10:
Sew the two layers of T-shirt as shown in the picture, turn it over and stuff the cardboard into the bunny ears.
Step 11:
Cut out a pair of ears of similar size from white coral velvet according to the shape of rabbit ears.
Step 12:
As shown in the picture, use hot melt glue to stick the coral fleece to the black T-shirt.
Step 13:
Use a hot glue stick to glue the two bunny ears to the blank headband, as shown in the picture. This completes the bunny ears.
Step 14:
Cut off the cuffs of the white shirt and replace the buttons on the sleeves with black buttons that have a more shiny effect as shown in the picture
Step 15:
Then put the completed black tight-fitting bra, bunny ears, cuffs, and the prepared bow together, and it’s done~
Tips:
Wear it quickly and try the effect~
