The most famous tree in the world may be the Christmas tree. It is usually made of pine, etc. It is absolutely indispensable at Christmas. Let me share a tutorial on how to make an origami Christmas tree. Even though there are a lot of steps, it is actually not difficult at all to divide it into several parts and fold them separately. Friends, if you want to fold a Christmas tree that suits the occasion, follow the instructions below and try it step by step!~
1. Prepare green square papers of different sizes.
1. Take dark green square paper.
2. Fold the edge in half.
3. After unfolding, fold the other side in half.
4. After opening, fold it diagonally.
5. Fully open.
6.Pinch the two opposite corners.
7. Gather along the crease.
8. Now lift one flap and insert your fingers into it to hold it up.
9. Flatten.
10. Repeat the steps on the remaining 3 sides.
11. Turn the front panel and flip the rear panel to the position shown here.
12. Now, pick up the front cover.
13. Stuff it inside. Repeat this step for the back cover as well.
14. What it looks like after completion.
16. Add glue dots and fold the trunk of the Christmas tree.
17. Take out a piece of light green square paper.
18. Fold the edges in half.
19. Fold the other side in half.
20. Fold diagonally again.
21.Pinch the two corners.
22. Gather along the crease.
23. Fold one bottom corner upward.
27. Fold the flap over and repeat steps on the remaining three sides.
28. What it looks like after completion.
29. Pull out a top corner.
30. Fold it like this.
31. Press tightly.
32. Then let go.
33. Fold the other sides in the same way.
34. Glue it together with the tree trunk.
35. Follow the same method, fold out another one and paste it on the upper layer.
36. Fold another small one and paste it on the upper layer.
37. Follow steps 3-12 to create this piece. Make sure you have a few glue dots on the small layer before placing the spire!
38. This three-dimensional Christmas tree origami is completed!
