This is a simple and fun piglet origami. After folding it, pull the strip of paper below to make it move! If you like it, just find a piece of scrap paper and fold it out~
If it is a rectangular paper, fold off one corner first, and then fold up the excess part below.
The line drawn above is the dividing line. After the upper part is expanded, a square will be obtained.
Cut along the drawn line, and don’t throw away the excess paper, as it will be useful later.
It is best to use scissors or a utility knife to avoid tearing.
Fold the square in your hand in half along the corners.
Open it and fold all four corners toward the center.
Turn it over and fold the four corners toward the center.
Turn it over again and fold the three corners toward the center, leaving one corner unchanged.
Then turn over to the back and pinch out the piggy ears. As shown in the picture, push up slightly with your thumb to flatten it, then do the other one.
Turn over to the front and tidy up the piggy’s face.
Then fold the small corner upward, and then press it to get the pigs nose.
Use a pen to draw the nostrils and eyes.
Fold the excess paper left over into a flat shape.
Then bend this end of the note.
Then insert the bent paper strip into the piggys body.
As long as you pull down the small paper strip, the piggys face will start to move! Pay attention to the width of the small paper strip, otherwise the fit will not be successful!
