A complete picture tutorial of how to weave a red rope bracelet for the Year of the Zodiac

The editor of the production department will share with you a simple way to weave a red rope bracelet today. I hope you will like it~
1. First, prepare the materials and tools needed to make the bracelet, with a diameter of 0.08mm. There are five red strings, and there is no limit to the number of beads. It is best to choose red beads for wiring. When you're ready, lets start editing. Start by aligning the lines of four equal-length red ropes, and then tie the four ropes together to create a knot. Be careful not to beat too tightly. Then lay the red rope flat on the table, as shown in Figure 2.

2. Start braiding the Vajra Knot, first takeTwo lines on the edge, as shown in picture 1, then put a line above the finger, as shown in picture 2, do not move the line that hits the circle, take another line from the bottom of the index finger through the circle above, as shown in picture 3 shows that the first line is tightened, as shown in Figure 4. After tightening, place the ring of your index finger on top of your index finger and repeat the above steps in sequence, and you are done.

3. Once you learn how to weave diamond knots skillfully, you can keep knitting diamond knots, and the length of the knots depends on the size of the beads. I am Braid 10 diamond knots. After braiding 10, put beads on the other two threads, as shown in Figure 2

4. Next, set the two lines into one set of lines respectively, and then start knitting two sets of lines, as shown in the picture. Note that these four lines are also woven simultaneously. After compilation, the lines will be loosened and then tidied up a bit. The two threads with the beads are pulled as short as possible. I think it looks good. This is purely a suggestion.

5. Repeat steps 2.3.4 and other steps, but pay attention to the direction. For example, the two threads used to braid the diamond knot for the first time will need to be strung with beads the second time. The directions are opposite, and the two threads used to string the beads must be braided. Diamond knots, and then keep appearing alternately until the length you want is braided. This is part of the picture I have braided, as shown in Figure 2.

6. After editing, it’s the end. Prepare another wire first. Then arrange all the threads at both ends of the braided bracelet and put them together, as shown in Figure 2. Put the threads at one end to one side and the other end to the other side. Separate as much as possible. After straightening the thread, fold the other thread in half, and use the eight threads of the bracelet as the axis to make a flat knot. . After braiding, cut off the excess thread.

7. For the remaining lines at the end, there are two ways to choose. No matter which one you choose, they all look good. One is to wear beads and string beads on the tail line. The second is braiding, braiding the figure eight knot, also known as the phoenix tail knot. The eight-character knot weaving method is very simple and you can learn it once you learn it. As for the weaving method, I won’t go into details. If you have relevant experience, you can learn it if you are interested.