Tools/Materials
Two wires (about 90cm each), pendant, lighter, scissors
Methods/Steps
1
First, prepare the materials to be used , red thread (choose by yourself, I personally recommend that the diameter of the red rope is 8mm), I used a red rope with a diameter of 8mm, pendant, (you can use whatever you like), tools lighter, scissors
Align the two red lines, then fold them in half to find the center point (it doesn’t have to be precise, just a rough position.), and then place your thumb in the center
Next, we start to weave the Vajra Knot. As for the steps of the Vajra Knot, I will not go into details. If you have relevant experience in knitting Vajra knots, you can refer to it. You can stop after knitting five Vajra knots. As shown in the picture.
Wear the prepared pendant with a thread, as shown in Figure 1, and thenMake five diamond knots equally on the other side. Pay attention to leaving a dotted line in the middle so that it is not too tight.
Next, leave a little distance and start braiding four diamond knots on each side. The distance becomes wider at a time, and then braid 3 knots. 2, 1. . Note that both sides must be symmetrical. (This is a pattern I designed myself. Of course, you can also think of it yourself, or you can make up 1 or 2 pieces at a time, and then increase the number)
6
